Bolly Wood Bangle
Bollywood Bangle
This stunning bangle was designed by Abi
Ingredients
Selection of Acholi Beads - Carnival Mix
6 x Silver Plated Lantern Beads
Bracelet Memory Wire
Additional Tools Required: Memory Wire Shears, Round Nose Pliers, Chain Nose Pliers
Method
1. Begin by cutting a length of memory wire that is approx 4 turns long.
2. Make a loop at one end of the memory wire using your Round Nose Pliers, snip off any excess wire from the loop and neaten off the loop with the Chain Nose Pliers so that there aren't any sharp edges.
3. Thread the beads onto the memory wire in the pattern shown.
4. Finish off the bangle by making another loop on the remaining end of the wire and once again snip off any excess with the Memory Wire Shears and neaten with the Chain Nose Pliers.
Top Tip: Many people find it difficult to make loops on Memory Wire - this is usually because they are trying to make the loops too close to the end of the wire which makes it very difficult. Instead make the loop approx 4cm from the end of the wire - this will make it much easier to pull the wire around to make the loop.